Your Advantages
- Designed for CRL Mirror Mount System Extrusions
- Helps Prevent Mirror Backing Failure Due to Moisture Build-Up
This CRL Mirror Mount Frame Cleat has a unique offset profile which holds a mirror away from direct contact with the wall surface, and also creates a pocket into which the Top Channel Cap or a Mirror Frame Extrusion fits. The unique offset profile of the cleat helps keep moisture from being trapped behind the mirror, while also concealing screws and support hardware. When used with a bottom FHA Type J-Bar, and a Top Channel Cap the system affords the installer a neat, trim way to mount mirrors with a narrow 5/16" (7.9 mm) frame.
If a fully framed system is desired use Mirror Frame Extrusion.
Hint: If using the Top Channel Cap, FHA J-Bar system, closed ends can be created by trimming back a portion of the J-Channel, and bending back the front flaps to close off the ends.
If a fully framed system is desired use Mirror Frame Extrusion.
Hint: If using the Top Channel Cap, FHA J-Bar system, closed ends can be created by trimming back a portion of the J-Channel, and bending back the front flaps to close off the ends.
Color | Mill |
Length | 3.66 m |
No downloads and documents available.
Not recommended for schools, hospitals or institutions where mirror edges should be protected on all four sides.
Material: 6063-T5 Aluminum Alloy
Thickness: .047 (1.19 mm)
Stock Length: 12' (3.66 m)
Typical Use: Holds mirror away from direct contact with the wall surface. Can be used with D1680 Mirror Frame Extrusion or D1638 Top Channel.
Thickness: .047 (1.19 mm)
Stock Length: 12' (3.66 m)
Typical Use: Holds mirror away from direct contact with the wall surface. Can be used with D1680 Mirror Frame Extrusion or D1638 Top Channel.
Shipping Information:
- Requires Cutting (max. 255 cm) to ship UPS. Additional charges apply.